• Qualified to MIL-PRF-81705E Type III, Class 2; listed on the QPL under the Defense Standardization Program
• Film printing per MIL-PRF-81705E Section 3.6 is a buried layer that will not rub-off or become removed with chemicals like IPA
• Film is printed per MIL-PRF-81705E Section 3.6
• Metal-In film laminate 0.0028” thick (2.8 mil)
• Dissipative Inner Surface Rs ≥ 1 x 10⁵ to < 1 x 10¹² ohms/sq per MIL-PRF-81705E Method 4.6.8 requirements
• Dissipative Outer Surfaces Rs < 1 x 1012 ohms/sq per MIL-PRF-81705E Method 4.6.8 requirements
• <10 nJ discharge shielding energy limit test per MIL-PRF-81705E Method 4.6.9
• Lead-free RoHS 2, REACH and Conflict Minerals Compliant
• Made in the United States of America

SCS Static Shield Film 81705 Series is manufactured from four layers - static dissipative coating, polyester, metal and polyethylene laminate. The polyester dielectric in concert with the metal layer provides discharge shielding. The exterior is static dissipative and allows electrostatic charges to be removed when grounded. Film is qualified to MIL-PRF-81705 Type III, Class 2.

MIL-PRF-81705E:

3.6 Identification of material. The barrier material shall have two groups of markings in block form and in machine direction. Group A marking shall state the specification number, type, class, manufacturer's name, manufacturer's designation, month and year of manufacture, lot number and heat sealing conditions (temperature, pressure and dwell time). The letters and figures shall be clear, legible, and shall be not less than ⅛ inch high. Group B markings shall identify the protective qualities of the materials as follows: For type I – EMI/STATIC SHIELD and for type III – STATIC SHIELD. These letters shall be not less than ½ inch high. The two groups of markings on all three types of material shall be either printed using a water-resistant ink or embossed and shall be visible if the material is fabricated into a bag or pouch. The two groups of markings shall be printed or embossed sequentially, complete, and continuous lengthwise with a space of one inch between groups. A complete group of markings shall appear once in each six inches of width of the roll and flat cut.